Charging, Battery, and Power

Charge the Controller

1. Place the controller on a firm, dry surface away from direct sunlight.
2. Connect the USB-C cable to the charging port.
3. Connect the other end to a compatible USB power source.
4. Allow the battery bars to cycle from one to three while charging.
5. When the battery bars turn off, disconnect the charging cable.

Battery Indicators

• Battery bars cycling: Charging is in progress.
• Battery bars off after charging: Charging is complete.
• Battery bars blinking during normal use: The battery is low; charge the controller before the next session.

Charging Safety

• Do not charge near water, on a soft surface, or in direct sunlight.
• Do not cover the controller while it is charging.
• Do not use the controller during charging.
• Stop charging and contact Zeno Labz if the controller or cable becomes unusually hot, swollen, damaged, or emits an unusual odor.