Quick Start Guide
Follow the essential steps to prepare, start, adjust, finish, and clean up after a Serenity session.
Getting Started
Follow these steps to prepare Serenity for your first session. Read the safety information before use.
1. Charge the Device
Fully charge Serenity using a compatible USB-C charging cable and power adapter.
2. Connect the Ear Clips
Insert the ear clip connector into the stimulation port beside the USB-C charging port. Make sure the connection is secure.
3. Prepare Your Earlobes
Clean both earlobes with an alcohol wipe or clean cloth. Allow the skin to dry completely.
4. Apply Conductive Gel
Apply a small, pea-sized amount of conductive gel to each ear clip’s contact surface.
5. Attach the Clips
Place one clip on each earlobe, ensuring both clips make secure, comfortable contact with the skin.
6. Start Your Session
Sit or lie down comfortably and press the Z button.
The device will briefly vibrate, and the Z button will pulse green to indicate that the session has started.
7. Adjust the Intensity
Allow the stimulation to increase gradually. Use the plus (+) and minus (-) buttons to adjust the intensity.
Start low and increase only as needed. Stimulation should never be painful or uncomfortable.
8. Finish Your Session
Serenity automatically ends each session after 15 minutes.
To stop early, press the Z button once.
Gently remove the clips, clean them as directed in After Use, Cleaning, and Storage, and allow them to dry before storage.
Important: Remain seated or lying down throughout the session. Stop using the device if you experience pain, dizziness, nausea, or other unexpected symptoms.